Then, when issuing FINS commands, or connecting the PLC to an HMI, you can just refer to it by its Network and Node number. Then tell it that you are labeling that local network as network 1 as shown below:Īll this means is that the network connected to unit #2 is now known as Network 1. I believe that it should tell you that it found a module. For instance, if the unit number dials on the Ethernet card say unit #2, right click on the 2 module and choose Insert CPU SIOU as shown below: Right click on the unit number that you want to set. Then go to Tools, Start Routing Table as shown:Ĭhoose FINS Local and then choose OK as shown: Then connect to the PLC by choosing Work online in the same menu.

First, go to communication settings in the Network pulldown menu as shown:Īnd set up your communications just as you would do for connecting with CX-Programmer.